Drum - Changing The Oil; Fuel Tank - Cleaning - Fayat Group Dynapac CC800 Instruction Manual

2
Fig. Drum, vibration side
1. Oil plug (1) in position
for draining the oil.
2. The oil plug position for level
check and filling.
1
Fig. Fuel tank
1. Hose from external pump
110

Drum - Changing the oil

Park the roller on a level surface, and drive the roller
slowly until the plug (1) is in the bottom position.
Place a receptacle that will hold at least 4 liters (1 gal)
under the plug.
1
Remove the plug (1) and let the oil run out.
Refit the plug. Top up with new oil in position 2. See
'Every 500 hours of operation' for filling oil.

Fuel tank - Cleaning

It is easiest to clean the tank when it is almost empty.
Pump out any bottom sediment using an external
pump.
To remove any additional bottom sediment, fill the tank
with two liters of diesel, and then pump it out using the
external pump.
4812160801_G.pdf
Maintenance - 2000h
Switch off the engine, disconnect the power and Switch off the engine, disconnect the power and
push in the emergency stop button. push in the emergency stop button.
Deliver the drained oil to special waste handling. Deliver the drained oil to special waste handling.
Collect in a container which holds at least 28 Collect in a container which holds at least 28
liters and deliver to special waste handling. liters and deliver to special waste handling.
Keep in mind fire risk when handling fuel. Keep in mind fire risk when handling fuel.
The fuel tank is made of plastic (polyethylene) The fuel tank is made of plastic (polyethylene)
and is recyclable. and is recyclable.
2020-10-27