Manual Vibration - Switching On; Braking; Normal Braking; Vibration On/Off - Fayat Group Dynapac CC800 Instruction Manual

Fig. Forward/Reverse lever
4. Switch, vibration On/Off
31
2
Figure. Control panel
2. Engine speed control
3. Emergency stop

4. Vibration On/off

6. Forward/reverse lever

31. Parking brake
2020-10-27

Manual vibration - Switching on

Engage and disengage vibration using the switch (4)
on the underside of the forward/reverse lever.
Always switch off vibration before the roller comes to a
standstill.
4

Braking

Normal braking

Braking is normally activated using the
forward/reverse lever. The hydrostatic transmission
brakes the roller when the lever is moved towards the
neutral position.
Press the switch (4) to switch off the vibration.
Move the forward/reverse lever (6) to the neutral
position to stop the roller.
3
6
4
4812160801_G.pdf
Vibration should not be active when the roller is Vibration should not be active when the roller is
stationary. This can damage both the surface and stationary. This can damage both the surface and
the machine. the machine.
When starting and driving a machine that is cold, When starting and driving a machine that is cold,
remember that the hydraulic fluid is also cold and remember that the hydraulic fluid is also cold and
that braking distances can be longer than normal that braking distances can be longer than normal
until the machine reaches the working temperature. until the machine reaches the working temperature.
Never leave the operator platform without Never leave the operator platform without
activating the parking brake (31). activating the parking brake (31).
Operation
47