Front Drum - Changing The Oil; Water Tank - Cleaning - Fayat Group Dynapac CC900G Instruction Manual

2
Fig. Drum, Drive side
1. Oil plug
2. Position for level check
1
Fig. Water tank
1. Cap
94

Front drum - Changing the oil

Loosen the oil plug (1) slightly, when it is in position for
level check (2), so that it can subsequently be
unscrewed by hand.
Park the roller on a level surface, and drive the roller
slowly until the plug (1) is in the bottom position.
1
Place a receptacle that will hold at least 4 liters (1 gal)
under the plug.
Remove the plug (1) and let the oil run out.
See under the section 'Every 500 hours of operation'
for filling oil.

Water tank - Cleaning

Empty the tank.
Clean the tank with water and a suitable detergent for
plastic surfaces.
Fill the tank with water and check that the sprinkler
works.
4812163901_A.pdf
Maintenance - 2000h
Switch off the engine, disconnect the power and Switch off the engine, disconnect the power and
push in the reserve/parking brake knob. push in the reserve/parking brake knob.
Deliver the drained oil to special waste handling. Deliver the drained oil to special waste handling.
Keep in mind that there is a risk of freezing in Keep in mind that there is a risk of freezing in
winter. Drain the tank, pump and lines. winter. Drain the tank, pump and lines.
The water tank is made of plastic (polyethylene) The water tank is made of plastic (polyethylene)
and is recyclable. and is recyclable.
2019-09-23