Maintenance - 2000H; Hydraulic Fluid Cooler - Cleaning - Fayat Group Dynapac CC800 Instruction Manual

Table of Contents

Advertisement

Fig. Engine compartment
1. Hydraulic fluid cooler
2020-10-27
1
4812160801_G.pdf

Maintenance - 2000h

Performed after 2000 operating hours (every two
years)
Park the roller on a level surface.
Park the roller on a level surface.
The engine must be switched off and the
The engine must be switched off and the
parking brake activated when checking or
parking brake activated when checking or
adjusting the roller, unless otherwise specified.
adjusting the roller, unless otherwise specified.
Ensure that there is good ventilation (air
Ensure that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
carbon monoxide poisoning.
Ensure that the engine cover is fully open when
Ensure that the engine cover is fully open when
work is being carried out under it
work is being carried out under it

Hydraulic fluid cooler - Cleaning

Clean the hydraulic fluid cooler's cooling flanges,
ideally with compressed air. Blow the cooler clean by
blowing air from the inside outwards.
Wear gloves and eye protectors when working
Wear gloves and eye protectors when working
with compressed air.
with compressed air.
Maintenance - 2000h
101

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dynapac cc900Dynapac cc1000Dynapac cc900g

Table of Contents