Electrical System; Fuses - Fayat Group Dynapac CC800 Instruction Manual

No No Designation Designation
24. 24. Warning lamp, oil Warning lamp, oil
pressure pressure
25. 25. Warning lamp, Warning lamp,
parking brake parking brake
26. 26. Fuel level Fuel level
27. 27. Warning lamp, Warning lamp,
water temperature water temperature
28. 28. Warning lamp, Warning lamp,
battery charging battery charging
29. 29. Warning lamp, Warning lamp,
glow plug glow plug
30. 30. Hourmeter Hourmeter
31. 31. Parking brake Parking brake
On/Off, switch On/Off, switch
Fig. Fuse box
Fuses in the fusebox Fuses in the fusebox
ECU Instrument panel, Sprinkler ECU Instrument panel, Sprinkler
1. 1.
Horn, Alternator, Fuel pump Horn, Alternator, Fuel pump
2. 2.
Right direction indicators, Side Right direction indicators, Side
3. 3.
repeaters repeaters
Left direction indicators, Side repeaters 5A Left direction indicators, Side repeaters 5A
4. 4.
36
Symbol Symbol

Electrical system

Fuses

The figure shows the position of the fuses.
The table below gives fuse amperage and function. All
fuses are flat pin fuses.
20A 20A
10A 10A
5A 5A
4812160801_G.pdf
Function Function
This lamp lights if the lubricating pressure in the This lamp lights if the lubricating pressure in the
engine is too low. Stop the engine immediately and engine is too low. Stop the engine immediately and
locate the fault. locate the fault.
The lamp lights when the parking brake is activated. The lamp lights when the parking brake is activated.
Shows the fuel level in the diesel tank. Shows the fuel level in the diesel tank.
The light comes on if the water temperature is too The light comes on if the water temperature is too
high. high.
If the lamp lights while the engine is running the If the lamp lights while the engine is running the
alternator is not charging. Stop the engine and alternator is not charging. Stop the engine and
locate the fault. locate the fault.
The lamp must go out before the starter switch is The lamp must go out before the starter switch is
moved to position 3c for activation of the starter moved to position 3c for activation of the starter
motor. motor.
Shows the number of hours the engine has run. Shows the number of hours the engine has run.
To activate the brakes, press the top of the switch to To activate the brakes, press the top of the switch to
change the position of the lever. change the position of the lever.
To disengage the brakes, press down the red part at To disengage the brakes, press down the red part at
the same time as the switch, and change the position the same time as the switch, and change the position
of the lever. of the lever.
NOTE: When starting the machine, the parking brake NOTE: When starting the machine, the parking brake
must be activated. must be activated.
Always use the parking brake when the machine Always use the parking brake when the machine
is stationary on a sloping surface. is stationary on a sloping surface.
Hazard beacon Hazard beacon
5. 5.
Direction indicators, Power socket 12V Direction indicators, Power socket 12V
6. 6.
Driving lights, Working lights main headlight Driving lights, Working lights main headlight
7. 7.
front front
Driving lights, Position lights, Brake lights, Driving lights, Position lights, Brake lights,
8. 8.
Working lights rear, Number sign lighting Working lights rear, Number sign lighting
Machine description
2020-10-27
10A 10A
10A 10A
15A 15A
15A 15A