31
Figure. Control panel
1. Starter switch
2. Engine speed control
3. Emergency stop
6. Forward/Reverse lever
20. Vibration switch man/auto
29. Glow lamp
31. Parking brake
2020-10-27
Starting
Starting the engine
29
Make sure that the emegency stop (3) is pulled out
20
and the parking brake (31) is activated.
Set the forward/reverse lever (6) in neutral. The
3
engine can only be started when the lever is in neutral.
1
Set the vibration switch (20) for manual/automatic
6
vibration in (position O).
2
At high ambient temperatures, set the speed control
(2) to the position just over idling.
Set the speed control to full speed when starting a
cold engine. Preheating: Turn key to position II. When
the glow lamp (29) goes off: Turn the starter switch (1)
to the right. As soon as the engine starts, release the
starter switch and reduce the engine speed to just
over idling (because high revs can damage a cold
engine). As soon as the engine is running smoothly,
reduce the revs down to idling.
Warm up the engine at idling speed for a few minutes,
although longer if ambient temperature is below +10°C
(50°F).
4812160801_G.pdf
The operator must remain seated when starting.
The operator must remain seated when starting.
Do not run the starter motor for too long. If
Do not run the starter motor for too long. If
the engine does not start, wait a minute or so
the engine does not start, wait a minute or so
before trying again.
before trying again.
Operation
43