Table of Contents
Advertisement
1
Fig. Drum, vibration side
1. Drain plug
Fig. Drum gearbox
1. Drain plug
2. Filler plug/Level plug
2023-01-25
Drum - Changing the oil
Position the roller with the drain plug (1) straight down.
Place a receptacle that will hold at least 7 liters (7.5
qts) under the plug.
Remove the drain plug (1). Allow all the oil to drain out.
Drain on both drum halves while refilling only is
necessary to do on one of the drum sides. (joint oil
bath)
See under the heading 'Every 500 hours of operation'
for filling oil.
Change the oil in both front and rear drum.
Drum gearbox - Oil change
Place the roller on a level surface.
Wipe clean, unscrew the plugs (1, 2) and drain the oil
into a suitable receptacle, capacity about 2 liters (0.5
2
gal.).
Refit the plug (1) and fill with oil up to refilling hole (2),
according to "Drum gearbox - Checking the oil level".
Use transmission oil according to the lubricant
specification.
1
Clean and refit the level plug/filler plug (2).
4812159901_D.pdf
Maintenance - 1000h
Deliver the drain oil to environmentally correct
Deliver the drain oil to environmentally correct
handling.
handling.
2
1
141
Advertisement
Table of Contents
