Operator Position - Fayat Group Dynapac CC800 Instruction Manual

2
1
4, 5
Fig. Operator's seat
1. Seatbelt
2. ROPS
4. Rubber element
5. Anti-slip
42

Operator position

Replace the seat belt (1) if it shows signs of Replace the seat belt (1) if it shows signs of
wear or has been subjected to high levels of wear or has been subjected to high levels of
force. force.
Never use the forward/reverse levers as a handle Never use the forward/reverse levers as a handle
when mounting or disembarking from the roller. when mounting or disembarking from the roller.
Check that the rubber elements (4) on the Check that the rubber elements (4) on the
platform are intact. Worn elements will reduce platform are intact. Worn elements will reduce
comfort. comfort.
Ensure that the anti-slip (5) on the platform is in Ensure that the anti-slip (5) on the platform is in
good condition. Replace where anti-slip friction is good condition. Replace where anti-slip friction is
poor. poor.
Machines with folding ROPS must always be Machines with folding ROPS must always be
operated with the ROPS raised and locked in operated with the ROPS raised and locked in
position. position.
The interlock must always be checked before The interlock must always be checked before
operating. To do this the operator stands up from operating. To do this the operator stands up from
the seat as shown in the instructions in the the seat as shown in the instructions in the
section Operation. section Operation.
If ROPS (Roll Over Protective Structure) is fitted to the
roller, always wear the seat belt (1) provided and wear
a protective helmet.
4812160801_G.pdf
Operation
2020-10-27