Changing The Oil In The Wheel Hubs - Fayat Group BOMAG BW 213 D-5 Operating Instruction

Fig. 182
8.9.6

Changing the oil in the wheel hubs

Maintenance – Every 1000 operating hours
5. Clean the area around the filler plug (2)
and the level inspection plug (1).
6. Unscrew the oil level inspection plug.
A second inspection plug is
located on the left front side of
the drive axle.
7. Unscrew the filler plug.
8. Fill in oil through the filler bore, until it starts
to run out through the level inspection bore.
9. After filling in oil wait until the oil has evenly
distributed inside the axle, if necessary fill
in some more oil.
10. Retighten level inspection and filler plugs.
11. Dispose of oil in an environmentally friendly
way.
NOTICE!
Components may get damaged!
– Drain gear oil only at operating
temperature.
– Use only gear oil of the permitted
specification
'Gear oil SAE 80W-140'
on page 179.
– Filling quantity:
'List of fuels and lubricants'
on page 180.
Perform this maintenance work at
the latest after one year.
BW 213 D-5
Ä Chapter 8.3.6
Ä Chapter 8.4
215