1
Figure. Cooling water container
1. Filler cap
2. Level marking
1
Fig. Drum drive side
1. Oil plug
2020-10-27
Check - Coolant system
Check that all hoses/hose connectors are intact and
tight. Fill with coolant as specified in the lubricants
specification.
Take great care when opening the radiator cap
Take great care when opening the radiator cap
while the engine is hot. Wear protective gloves and
while the engine is hot. Wear protective gloves and
goggles.
goggles.
2
Also check the freezing point. Change the coolant
Also check the freezing point. Change the coolant
every other year.
every other year.
Drum - Checking the oil level
Park the roller on a level surface, and drive the roller
slowly until the oil plug (1) is in the middle of the
semicircle shaped notch in the drum suspension.
Switch off the engine, disconnect the power and
Switch off the engine, disconnect the power and
push in the emergency stop button.
push in the emergency stop button.
Unscrew the plug and check that the oil level reaches
the hole's lower edge. If necessary, top off with fresh
transmission fluid. See under the heading lubricants
for correct fluid grade.
Clean the magnetic oil plug (1) from any metallic
residue, and refit the plug.
4812160801_G.pdf
Maintenance measures - 500 h
91