10.2.3 Display contents of Communication Detail setting
The contents of communication detail setting varies according to driver type.
This section explains setting items different from the communication detail setting of the drawing software.
For setting items other than described in this section, refer to the following manual.
Communication detail setting of host (modem)
On the communication detail setting screen of host (modem), the communication setting between the GOT and the
modem and the modem operation can be executed.
PC connection type
Select the connection method to the PC.
Set the transmission speed when communicating.
Set the data bit when communicating.
Set the stop bit length when communicating.
Set whether to execute or not the parity check during
communication. When executing, set the type of the parity check.
Init. AT command
Set the AT command for initialize the modem.
Touch the [Init.] button to initialize the modem.
Touch the [Cut] button to disconnect the line.
10 - 10
10. COMMUNICATION INTERFACE SETTING (COMMUNICATION SETTING)
10.2 Communication Detail Setting
GT Designer3 Version1 Screen Design Manual (Fundamentals)
Host (PC) / Host (Modem)
<Default: Host (PC)>
7bit/8bit <Default: 8bit>
1bit/2bit <Default: 1bit>
Odd/Even/None <Default: Odd>
<Default: AT & FE0%C0 & K0 & D0W2S0=1>