Setting The Parameters Of An Ethernet Module - Burkert 8619 Operating Instructions Manual

9.27

Setting the parameters of an Ethernet module

Checking the IP address of an Ethernet version
Before installing an Ethernet version to the network, make sure that the IP address of the device
Type 8619 is not already used by another equipment.
→ If necessary, change the IP address of the device.
Refer to section 8.10 to access the "Parameters" menu.
Parameters M1: Ethernet
This is
when the
device is be-
ing parame-
tered............
....................
1) If "Unit group" ≠ "ON/OFF" and ≠ "Custom"
2) If "Unit group" = "Custom"
PROTOCOL: Choose the type of protocol. Default protocol is Modbus TCP. Others protocols are available
only if the software option "ethernet protocols" is activated. See section 9.5.
IP SETTINGS: Choose the IP settings of the device.
• MODE: Choose the configuration mode of the IP settings for the device.
- DHCP: The IP address of the device is automatically affected by a DHCP server.
- BOOTP: The IP address of the device is affected by a BOOTP server.
- DCP: The IP address of the device is affected by the DCP protocol.
- DHCP+BOOTP: The device is trying to obtain its IP address first by a DHCP server otherwise by a
BOOTP server.
- MANUAL: Enter manually the IP address of the device, the Gateway of the network and the Netmask of
the network.
140
Protocol
This is
when the
device is be-
ing parame-
tered............
....................
IP settings
Device name
MAC Address
Ethernet units
Units PVN1-10
Units PVN11-20
English
Modbus TCP
EtherNet/IP
only if the software option "Ethernet protocols" is
activated. See section 9.5
PROFINET
Mode DHCP
BOOTP
DHCP+BOOTP
DCP
Manual
IP Address ENTERING
Netmask ENTERING
Gateway ENTERING
ENTERING
if "Protocol" = "PROFINET"
Read only if "IP settings" ->"Mode" = "DCP"
READING
READING
°C - L/min
°C - ImpGPM
°F - GPM
PVN1
Unit group:
...
Unit selection
PVN20 Text
Format
Type 8619
Parameters menu
if "Protocol" = "Modbus TCP" or
"EtherNet/IP"
if "Protocol" = "Modbus TCP"
if "Protocol" = "PROFINET"
if "manual" is
activated
1)
Unit list:
2)
Manual entry