Setting The Parameters Of The Analogue Inputs - Burkert 8619 Operating Instructions Manual

9.24

Setting the parameters of the analogue inputs

Refer to section 8.10 to access the "Parameters" menu.
Mx:Inputs
Parameters
This is
when the
device is be-
ing parame-
tered............
....................
MODE: Choose the input signal type, current or voltage.
RANGE: Choose the range of the input signal, depending on the choice made in "MODE".
UNIT: Choose the units associated to the input signal. The following choices are possible:
• CUSTOM: To enter a customized text for the unit and choose the displayed format of the process variable.
• NO UNIT: To allow a very high range of values.
• Selection of units related to the process variables. The following uses cases are possible:
- Configure an arithmetic function that uses the input signal and a PV coming from a measurement
sensor connected to the device. Then, assign the unit of the PV to the input signal. Refer to
section 9.14.
- Configure a PID function that uses the input signal and a PV coming from a measurement sensor
connected to the device. Then, assign the unit of the PV to the input signal. Refer to section 9.18.
TEXT: If UNIT is set to CUSTOM, choose MANUAL ENTRY to enter a customized text or choose UNIT LIST
to select a unit of the list.
FORMAT: If UNIT is set to CUSTOM, choose the displayed format of the process variable with different
accuracies (0 / 0.0 / 0.00 / 0.000).
132
AI1/AI2
This is
when the
device is be-
ing parame-
tered............
....................
English
Mode: None
Current
Voltage
Range: 0...20 mA
4...20 mA
0...2 V
0...5 V
0...10 V
Unit
Text Unit list:
Manual entry
Format
0 mA/4 mA: ENTERING
20 mA: ENTERING
0 V: ENTERING
2 V / 5 V / 10 V: ENTERING
Filter: None
Fast
Slow
Type 8619
Parameters menu
if "Mode" = "Current"
if "Mode" = "Voltage"
if "Unit" = "Custom"
if "Mode" = "Current"
if "Mode" = "Voltage"