Table of Contents
Advertisement
Type 8619
Parameters menu
9.23
Setting the parameters of the digital inputs
This function is available if the software option "FLOW" is activated. See section 9.5.
Refer to section 8.10 to access the "Parameters" menu.
Parameters
M0:Inputs
This is
when the
device is be-
ing parame-
Mx:Inputs
tered............
....................
This is
when the
device is be-
ing parame-
tered............
....................
1) The choices offered depend on the modules fitted. See section 15 Process variables.
9.23.1
Choosing the units for the totalisers
TOTALIZER A/B UNIT: Select the units. The chosen unit is available in any place where the process value
associated to the totaliser is selected.
9.23.2
Remotely reset the value of a totaliser
REMOTE RESET:
• STATE: choose ON to activate or OFF to deactivate the reset of the totaliser value over a PV.
• PV: if STATE is set to ON, choose the PV that resets the totaliser.
• ACTIVE: if STATE is set to ON, choose HIGH if you want that the high value of the PV ("ON") triggers the
reset of the totaliser or choose LOW if you want that the low value of the selected PV ("OFF") triggers the
reset of the totaliser.
9.23.3
Remotely freeze the last value of a totaliser
REMOTE HOLD:
• STATE: choose ON to activate or OFF to deactivate the freeze of the totaliser value over a PV.
• PV: if STATE is set to ON, choose the PV that freezes the last value of the totaliser.
• ACTIVE: if STATE is set to ON, choose HIGH if you want that the high value of the PV ("ON") triggers the
freeze of the totaliser or choose LOW if you want that the low value of the selected PV ("OFF") triggers the
freeze of the totaliser.
DI1/DI2
Totalizer A/B
L
Totalizer A/B unit
m3
gal
Impgal
State
Remote reset
PV
Active
Remote hold
State
PV
Active
English
ON / OFF
M0:MAIN
M1:
... 1)
Mx:
High / Low
ON / OFF
M0:MAIN
M1:
... 1)
Mx:
High / Low
131
Advertisement
Chapters
Table of Contents
