Process Variables; On The M0:Main Board - Burkert 8619 Operating Instructions Manual

15

PROCESS VARIABLES

This chapter describes the process variables (PV) that are available on each extension module. The PV can
be e.g. process inputs, PVNs, PVCs. The list of avalaible PVs depends on the modules fitted and on the
options activated:
• Section 15.1 describes the PV available on the M0:Main board.
• Section 15.2 describes the PV available on the M1:Ethernet module.
• Section 15.3 describes the PV available on the input module.
• Section 15.4 describes the PV available on the pH/ORP module.
• Section 15.5 describes the PV available on the conductivity module.
• Section 15.6 describes the PV available on the additionnal output module.
15.1

On the M0:MAIN board

M0:MAIN None
Constant
Warning
AO1
AO2
DO1
DO2
SysSwitch
DI1
DI2
DI1: Qv
DI2: Qv
DI1: TotA
DI1: TotB
DI2: TotA
DI2: TotB
DI1: Hz
DI2: Hz
Fx:
PVCx
Only the compatible PVs are displayed.
Example: for the configuration of an analog output (AO), the PVs "Warning", "SysSwitch", "DI1" and
"DI2" are not displayed.
"Constant" = value entered by the user
"Warning" = event generated by the device
"AOx" = analogue output
"DOx" = digital output
"System switch" = when the corresponding event is configured and activated
"DIx" = digital input
"DIx Qv" = flow rate on digital input DIx
196
Available on the device if the software option "FLOW" is active.
See section 9.5.
English
Type 8619

Process variables