Wiring The Industrial Ethernet - Burkert 8619 Operating Instructions Manual

7.3.12

Wiring the Industrial Ethernet

WARNING
Risk of injury due to non-conforming installation.
▶ Electrical installation can only be carried out by qualified and skilled staff with the appropriate tools.
RJ45 port
Fig. 23: Pin assignment of each RJ45 port
You can prepare a connection cable for wall-mounted version as described below, or you can use an
adapter RJ45-M12. See chapter 17.
Preparing a connection cable for a wall-mounted version:
→ Choose an RJ45 male connector for industrial use
Shielded cable
Minimum category
Length
→ To make sure the door of the device can be fully closed, use RJ45 male connectors with maximum
dimensions of 45 mm including the bend radius of the Ethernet cable.
→ Insert the cable via the cable gland of the device.
→ Insert the wires as specified by the manufacturer of the RJ45 male connector and according to
ISO / IEC 11801.
→ Crimp the RJ45 male connector.
→ Insert the RJ45 connector in the RJ45 port.
→ Do the settings of the Ethernet connection. Refer to the Supplement related to the digital communication
for the Type 8619, available on: country.burkert.com.
54
1 2 3 4 5 6 7 8
English
Type 8619
Installation and wiring
Pin
1
2
3
4
5
6
7
8
Housing
minimum required: FTP
5e / CAT-5
max. 100 m
Pin assignment
TX+
TX–
RX+
N. C.
N. C.
RX–
N. C.
N. C.
FE