Installation Procedure; Installing A 8619 Multicell On An Enclosure Or Electrical Cabinet - Burkert 8619 Operating Instructions Manual

Type 8619
Installation and wiring
7.2

Installation procedure

1. To carry out mechanical installation: Depending on the version, follow the instructions in section 7.2.1 or
7.2.2.
2. To wire the device: Depending on the version, follow the instructions in section 7.3.
7.2.1 Installing a 8619 multiCELL on an enclosure or electrical
cabinet
→ Follow the instructions below to mount the device, delivered fully assembled, onto an enclosure or
cabinet.
92 +0,5/-0
5,5
This diagram is not to scale.
The dimensions are given in mm.
Screw
5,5
Body
x4
1
2
Step 1:
→ Check that the thickness of the door of the
enclosure or cabinet is less than 4 mm.
→ Ensure there will be sufficient space around the cut
out hole and on the inside of the cabinet to easily
accommodate the 4 fasteners.
→ Cut a hole in the door of the enclosure or electrical
cabinet according to standard CEI 61554:1999
(DIN 43700).
Step 2:
Prepare the 4 fasteners:
→ Insert a screw into each device.
→ Tighten the screw until the end of the shaft of the
screw is flush with the device.
Step 3:
→ Slide the housing into the cut-out with the con-
nectors to the back, until it can go no further.
Step 4:
→ Insert (1) the hooks on the first fastener into the
slots on the housing.
→ Pull the fastener (2).
English
41