Setting The Parameters Of The Current Outputs - Burkert 8619 Operating Instructions Manual

9.25

Setting the parameters of the current outputs

Refer to section 8.10 to access the "Parameters" menu.
Parameters M0:Outputs
This is
when the
device is be-
ing parame-
Mx:Outputs
tered............
....................
1) T he choices offered depend on the modules fitted and/or the options activated. See section 9.5 Consulting and/or
activating the available software options and section 15 Process variables.
PV: Choose the process input associated with the current output.
4 MA: Choose the value of the process input previously selected, associated with a current of 4 mA, for
each current output. See Fig. 90.
20 MA: Choose the value of the process input previously selected, associated with a current of 20 mA, for
each current output. See Fig. 90.
P and P are the values associated with a current of 4 mA or 20 mA respectively.
1 2
If P is higher than P
1
20...4 mA current.
Fig. 90: 4...20 mA current depending on the PV selected
FILTER: Choose the level of attenuation for the fluctuations of the current value for each current output. See
Fig. 53: Filtering curves.
DIAG. EVENT : Choose to emit a current of 22 mA on the current output selected when an "error" event
related to diagnostics (see sections 11.3 to 11.7) is generated by the device or allow the current output to
operate normally (choose "none").
See also "If you encounter problems" in section 16.3.
134
AO1/AO2
This is
when the
device is be-
ing parame-
tered............
....................
, the signal is inverted and the range P
2
mA
20
4
0
English
PV M0:MAIN
M1:
...
1)
Mx:
4 mA: ENTERING
20 mA: ENTERING
Filter: None
Fast
Slow
Diag. event None
22 mA
– P corresponds to the range for the
1 2
P P
1 2
Type 8619
Parameters menu