Burkert 8619 Operating Instructions Manual page 117

Type 8619
Parameters menu
Parameters Functions
This is
This is
when the
when the
device is be-
device is be-
ing parame-
ing parame-
tered............
tered............
....................
....................
SP LIMITS: Set the low and high limits of the setpoint value in order to limit the working range of the
setpoint.
CUTOFF: Force or do not force the module output to 0 % or 100 % if the setpoint value is outside a range
defined by "Cut-" and "Cut+", or under the low range "Cut-", or above the high range "Cut+".
Fx: (CMD) (%)
100
99
98
97
96
5
4
3
2
1
Fig. 75: "CUTOFF" graphs
CMD SAFE: Confirm (select "Mode: ON") or do not confirm (select "Mode: OFF") the use of a fallback
position on the output when the "System switch" event (see section 9.21) has the state "ON". When use of
the fallback position is confirmed, enter a fallback position value of 0...100 % for each output.
F1...F12:
PID
.
.
.
Setup Advanced
Fx: (CMD) (%)
100
99
98
97
96
5
4
3
2
1
Setpoint (SP)
SP limits: State:
SPlimits-
SPlimits+:
CutOff: Mode:
Cut-:
Cut+:
CMD SAFE Mode:
Channel 1/2:
Channel 1/2:
Inversion
Setpoint (SP)
English
ON
OFF
ENTERING
ENTERING
OFF
Cut-
Cut+
Cut-Cut+
ENTERING
ENTERING
ON
OFF
ENTERING
ON
OFF
117