Table 4-1 Utility And Wiring Information; Table 4-2 Output Characteristics For Dvs100 - Webasto DVS100 Installation, Operation And Maintenance Manual

Input voltages
Input AC Current at rated load (Amps)
Input Frequency (Hz)
Number of input Phases (Excluding Ground)
Maximum Circuit Breaker Rating (Amps)
Minimum Disconnect Switch Voltage Rating (VAC)
Minimum Inrush Current Capacity (Amps)
THD Max
Minimum Input Conductor Size (mm
Minimum Grounding Conductor Size (mm
Minimum Ground Wire Terminal Torque (in-lb)
Configuration
Max Output Power
Max Output DC Range
Max Output DC Current
Minimum Output Wire Size (DC BUS +)
Minimum Output Wire Size (DC BUS -)
Output Cable Connector
Installation / Line Voltage Changeover Instructions
1. Remove the screws and open the front door of the DVS100.
2. Locate the AC Input Terminal Block. Refer to Figure 4- 3.
3. Bring utility wires from the Utility Distribution Panel through conduit, and route them to the AC
Input Terminal Block and the Chassis Grounding Connector.
NOTE: The grounding wire should have insulation that is green or green with yellow stripe.
4. Ensure good electrical connection by tightening all the screws properly.
5. Close the front door prior to switching on the utility power.
20182-W-03-01
IMPORTANT INFORMATION – SAVE THESE INSTRUCTIONS

Table 4-1 Utility and Wiring Information

Configuration
2
)

Table 4-2 Output Characteristics for DVS100

DVS100 Installation, Operation and Maintenance
2
)
Port A
10 kW
16-120 V
200 A
1x 70 mm²
1x 70 mm²
320A Euro
11
2 x 10kW
440 VAC ± 10%
30 A @ 440V
50 / 60
3
30 A, D-characteristic
600
250A, 2 cycle start-up load
35%
2
10mm
2
10mm
4-5 Nm
Port B
10 kW
16-120 V
200 A
1x 70 mm²
1x 70 mm²
320A Euro
Webasto Charging Systems, Inc.