Table of Contents
Advertisement
2
General Information
2.1
Purpose of the document
This document is part of the product and contains information
for electricians to carry out safe installation in accordance with
local regulations, standards, and requirements.
The updated version of the manual can be found on our
website:
https://www.evsolutions.com/ev-charging-product-resources.
NOTE
In addition to this document, follow and comply with
local regulations and standards relating to operation,
installation, and environmental protection.
2.2
Using this document
– Read this document carefully before installing and
starting the TurboConnect Charge Station.
– Keep these instructions ready to hand.
– Keep these instructions for future reference.
NOTE
We would draw your attention to the fact that, as
part of a professional installation, an installation log
should be drawn up by the installer. We also request
that you fill in our checklist. See chapter 23, "Checklist
for the installation of the Webasto charge station" on
page 23.
NOTE
Individuals with a deficiency in their color vision require
support in the allocation of all fault indicators.
2.3
Intended use
The TurboConnect Charge Station is designed for charging
electric vehicles in accordance with SAE J1772, charge Level 2.
In this mode, the charge station ensures that:
– The voltage is not applied before the vehicle has been
properly connected.
– The maximum power is calibrated.
– The AC/DC converter is in the vehicle.
The charge station does not support ventilation, therefore if
the EV (electrical vehicle) requests ventilation, the EVSE (electric
vehicle supply equipment) will not energize the system.
Webasto TurboConnect
2.4
Use of symbols and highlighting
DANGER: This signal word denotes a hazard with a
high degree of risk which, if not avoided, will lead to
death or serious injury.
WARNING: This signal word denotes a hazard with a
moderate degree of risk which, if not avoided, may lead
to minor or moderate injury.
CAUTION: This signal word denotes a hazard with a
low degree of risk which, if not avoided, may lead to
minor or moderate injury.
NOTE: This signal word denotes a Special Technical
Feature or (if not observed) potential damage to the
product.
Refers to separate documents which are enclosed or
can be requested from Webasto.
2.5
Warranty and liability
Webasto shall not assume liability for defects or damage
resulting from the installation and operating instructions being
disregarded. This liability particularly applies for:
– Improper use.
– Repairs carried out by an electrician not contracted by
Webasto.
– Use of non-original spare parts.
– Unauthorised conversion of the unit without permission
from Webasto.
– Installation and commissioning by unqualified staff (not
an electrician).
– Improper disposal after decommissioning.
WARNING
Installation and connection of the charge station must
only be carried out by a qualified electrician.
The symbol of a bin with a line through means
that the instructions in chapter 18, "Disposal" on
page 20 must be followed.
2.6
STATE OF CALIFORNIA PROPOSITION
65 WARNINGS
WARNING
This product can expose you to chemicals including
Styrene which is known to the State of California to
cause cancer and Bisphenol A, which is known to
the State of California to cause birth defects or other
reproductive harm.
For more information go to:
www.P65Warnings.ca.gov.
2.7
Software Licenses
This product uses open-source software. Further information,
such as disclaimers, written offers, and license information can
be found via the integrated web server. The web server can be
reached via the hotspot (https://172.0.2.1/licensing.html).
2.8
Trademark and Copyright
This product is protected by the copyright laws of the United
States, Canada, and other countries. It may not be modified,
reproduced, or distributed without the prior, express written
consent of Webasto. Webasto and TurboConnect are U.S.-
registered trademarks and cannot be used without the prior
written consent of Webasto. Webasto Charging Systems, Inc. All
rights reserved. ©2023
3
Safety
3.1
General Information
The TurboConnect Charge Station has been developed,
produced, tested, and documented according to the relevant
safety regulations and environmental requirements that apply to
your geographical area.
You must only use the charge station in a technically faultless
condition. Any malfunctions that adversely affect the safety
of persons or the device must be immediately rectified by a
qualified electrician in accordance with applicable regulations
and warranty conditions. You are prohibited from modifying,
changing, or manipulating the device.
NOTE
Signaling in your vehicle may differ from that described
in this guide. Always read and observe the vehicle
manufacturer's user manual.
EN
7
Advertisement
Table of Contents
