Ventilation System - Webasto DVS100 Installation, Operation And Maintenance Manual

5.11.9 Ventilation System

NOTE: This section is only applicable if a ventilation system has been installed and
connected to the charger.
The Ventilation System menus allow the user to set the ventilation system control parameters.
From this menu, the charger may be configured to turn the ventilation system off, to turn it on only
during Equalization, or to turn it on any time the vehicle is being charged.
From the "Ventilation System" screen Press <enter> and then Press <enter> again and the status
(ON or OFF) will flash. Press <up> or <down> to toggle between ON and OFF. Press <enter>
again to accept your selection. Press <clear> to exit.
CLEAR
20182-W-03-01
IMPORTANT INFORMATION – SAVE THESE INSTRUCTIONS
Ventilation System
Configuration
ENTER
CLEAR
Ventilation System
OFF
ENTER
Ventilation System
ON When Charging
Ventilation System
ON When EQing
Figure 5- 21 Ventilation System Setup
DVS100 Installation, Operation and Maintenance
Charger Configuration
CLEAR
Verify Ventilation
ENTER
Connection
CLEAR
Verify Ventilation
ENTER
Connection
CLEAR
36 Webasto Charging Systems, Inc.