Webasto DVS100 Installation, Operation And Maintenance Manual page 50
Mhe intelligent fast charging systems
Hide thumbs
Also See for DVS100:
- Installation manual (20 pages) ,
- Installation manual (16 pages) ,
- Installation manual (16 pages)
Table of Contents
Advertisement
To install output cable(s):
Install output cable(s) ensuring mounting screws and lock washers are properly installed and
1.
tightened. Recommended torque: 8.47 Nm (75 in-lbs)
Proper Cable management system is required to relieve stress concentration from output
2.
connector mounting hardware areas
Note: 1) Do not remove connector key(s) from Connector
2) Minimum bend radii 9cm (3.5 inch) are required for output cables
20182-W-03-01
IMPORTANT INFORMATION – SAVE THESE INSTRUCTIONS
DVS100 Installation, Operation and Maintenance
44
Webasto Charging Systems, Inc.
Advertisement
Table of Contents
