Auto Eq; Fast Charge Soc Limit - Webasto DVS100 Installation, Operation And Maintenance Manual

5.11.4 Auto EQ

Auto EQ:
ON

5.11.5 Fast Charge SOC Limit

The charger can be configured to allow fast charging of batteries only up to a fixed percentage.
This percentage of battery state of charge is calculated when the battery is first connected to the
charger and is updated as the charging progresses. If a battery is charged up to this limit and is
not scheduled to full charge or equalize, the charging is stopped. If the charger is configured for
full charging or equalizing during this period, charging will proceed past this SOC limit as the
charger enters the full charge or equalization state.
This fast charge limit is also used in conjunction with the BMID programmed fast charge limit. The
lower of these two parameters are used to terminate a fast charge session. This parameter can be
set to 100% to allow only the BMID SOC limit to be the limiting point. If backup battery (or ultra-
cap) power is lost, this parameter will need to be review and/or updated, as it will be set to a default
value in this case.
Fast Charge SOC
Limit
Use the UP and DOWN arrow buttons to set the parameter to the appropriate value.
Press ENTER again to accept the selection made.
Press CLEAR to retain the original value
20182-W-03-01
IMPORTANT INFORMATION – SAVE THESE INSTRUCTIONS
ENTER
Press ENTER to accept the selection made.
Press CLEAR to retain the original value.
Figure 5- 16 Auto EQ Menu
Figure 5- 17 Fast Charge SOC Limit Screens
DVS100 Installation, Operation and Maintenance
CLEAR
Auto EQ:
OFF
Charger Configuration
CLEAR
ENTER Fast Chrg SOC Limit:
100%
32
Charger Configuration
Webasto Charging Systems, Inc.