Equalization - Webasto DVS100 Installation, Operation And Maintenance Manual

LED Label
Equalizing
Charge
Complete
80% Charged
Charging
Fault/Warning
Step 2: Stop Charging
Once the battery has been fast-charged to the SOC preset in the BMID or Charger, the
DVS100 will stop the charge and illuminate the "Charge Complete" LED. If an equalization
charge is scheduled for this battery pack, the Charge Complete will not illuminate until the
equalization has been completed. The operator may stop charging at any time without waiting
for the charge to complete, by pressing the "STOP" button or disconnecting the battery cables
from the charger.
After a charge has been completed or stopped by the user, the screen will indicate the method
in which the charge was stopped and the data values just before the end of charging will be
displayed (see Figure 5- 5).
C h g C o m p l e t e
6 2 . 0 V
Step 3: Disconnect battery cables from charger
NOTE: If the operator disconnects the cables without pressing STOP, the charger will
20182-W-03-01
IMPORTANT INFORMATION – SAVE THESE INSTRUCTIONS
Color When Steady Lit
green Battery undergoing

equalization

green Charge Complete and stopped N/A
green The Battery SOC is >= 80%
amber Battery connected and
charging
red Fault (charge stopped)
1 0 0 %
0 A 2 3 C
Figure 5- 5 Charge Complete Screens
immediately stop charging and prevent any arcing.
DVS100 Installation, Operation and Maintenance
C h g S t o p p e d
Or
5 1 . 8 V
16
When Flashing
Equalization
scheduled
N/A
N/A
Warning (check log)
6 2 %
0 A 1 0 C
Webasto Charging Systems, Inc.