External Lights 1, 2 And 3; Eq Button Action; Setting The Eq Button Action - Webasto DVS100 Installation, Operation And Maintenance Manual

5.11.2.2

External Lights 1, 2 and 3

 Press <enter> to display the Light 1 setting. Figure 5- 14)
 Press <enter> again to select from the 5 Charger states of operation.
 Use the <up> and <down> buttons to choose the charger state you wish to monitor.
 Once the desired state is displayed, press <enter> to store the edited value.
 Press <clear> to exit.

5.11.3 EQ Button Action

The EQ Button Action menu is used to configure the actions of the front panel EQ button. The
three valid configurations are:
1. ALWAYS_ACTIVE – The EQ button is always active.
2. DISABLED – The EQ button is disabled.
3. WORKS_ON_EQ_DAY_ONLY – The EQ button works on scheduled EQ day only.
CLEAR
5.11.3.1

Setting the EQ Button Action

From the "EQ Button Action" screen, press <enter> to display the current EQ button configuration.
Press <enter> again and the programmable parameter will flash. Use the <up> and <down>
buttons to toggle parameters. The display will continue to flash until you press <enter> to set the
displayed parameter. Press <clear> to exit.
DISABLED - This setting causes the charger to ignore the EQ button.
ALWAYS ACTIVE - This is the default setting and causes the EQ button to be active at all times.
WORKS ON EQ DAY ONLY - This setting causes the EQ button to function only on the day of the
week programmed in the BMID for equalization.
20182-W-03-01
IMPORTANT INFORMATION – SAVE THESE INSTRUCTIONS
EQ Button Action
Configuration
ENTER
EQ Button Action:
Always Active
ENTER
EQ Button Action:
WORKS ON EQ DAY ONLY
EQ Button Action:
Disabled
Figure 5- 15 EQ Button Action
DVS100 Installation, Operation and Maintenance
Charger Configuration
CLEAR
ENTER
Press ENTER to accept the selection made.
After pressing ENTER, press CLEAR to retain
the original value.
31 Webasto Charging Systems, Inc.