2.2
Technical Support
This manual is intended to provide an authorized, fully trained installation technician with the
information and guidance necessary to safely install the DVS100 equipment.
All non-standard tools are listed in 2.4. If parts or tools are needed in addition to those listed in this
manual to perform service, this service is outside the scope of this manual and Webasto should be
contacted directly for further assistance.
Training may be scheduled by contacting Customer Service at Webasto at:
2.3
ESD Precautions
Electronic circuits are sensitive to damage from electrostatic Discharge. Persons servicing this
equipment should be trained in proper techniques for avoiding ESD damage to electronic circuits.
As a minimum, when handling circuit boards, wear an appropriate ESD wrist strap connected to the
equipment chassis.
2.4
Non-StandardTools
No.
Equipment Description
A.
Multimeter
B.
Bleed down resistor (100, 10W)
with Probe tips
C.
Metric socket set, deep well, 8MM to
17MM
D.
RS-232 Diagnostic Cable
20182-W-03-01
IMPORTANT INFORMATION – SAVE THESE INSTRUCTIONS
info@posicharge.com
866-POSICHARGE (866-767-4242
DVS100 Installation, Operation and Maintenance
Suggested Supplier
Fluke
---
---
---
4
)
Part Number
Model 79 or
equivalent
---
---
---
Webasto Charging Systems, Inc.