Fault And Warning Screens - Webasto DVS100 Installation, Operation And Maintenance Manual

1. Charging data. This screen displays the voltage, current, state-of-charge, and temperature
of the battery. During a charge, the screen will say "Charging" and the data will be updated
periodically.
2. Charge start data. This screen shows the charge start date & time, as well as the voltage,
state of charge, and temperature of the battery when charging started.
3. Charge time and Amp-hours. This screen shows how long the battery has been under
charge and how many ampere-hours have been returned to the battery. During charging,
this data is updated periodically. After a charge is complete or stopped by the user, this
screen retains the final charge time and amp-hour values.
4. Battery type. This screen shows the Type code programmed into the BMID, along with a
description of that type.
5. Battery configuration. This screen shows the other battery configuration information
programmed into the BMID: identification number, number of cells, capacity, and voltage.
6. Charger Configuration. This screen shows the charger model number and software version.
7. Date & Time. This screen shows the current date and time.
8. Fault Description. If there is an active fault or warning, the fault or warning code and
description are displayed. See Section 5.5 for further information on Faults and Warnings.
5.7

Fault and Warning Screens

Fault/Warning Screens
In the event of a fault or a warning, a fault/warning screen will appear automatically (see Figure 5-
7). The other screens shown above remain available through use of the up & down arrow buttons.
If there is more than one fault or warning, there will be a screen for each one. The fault/warning
screen shows an assigned fault number and the name, which indicates the type of fault or warning.
The Fault/Warning Log data screens (see Figure 5- 8) allow the user to review the data from the
last 50 fault or warning events in the charger. These data are stored in the charger and are
preserved even if power is cut and restored to the charger.
1. Event ID screen - Shows the active (most recent) fault or warning event. Using the UP and
DOWN arrow keys, scroll through the last 50 fault or warning events. For each fault or warning
event, the date and time will be recorded to help locate a particular event. Once the desired
event is displayed, press ENTER to open the log for that event. At any point in the log file press
CLEAR to return to the Event ID screen.
2. Fault/Warning Code - Shows the fault code and the name of the selected fault or warning event.
Check Table 6- 1 and Table 6- 2 for a complete listing of faults and warnings.
3. Clearance Date - Shows the date and time that the fault was cleared.
Pre-fault State - Shows the state of the charger when the fault or warning occurred. Either
4.
"Charging battery XXXXXXXX" or "Idle".
20182-W-03-01
IMPORTANT INFORMATION – SAVE THESE INSTRUCTIONS
Figure 5- 7 Fault or Warning Screens
DVS100 Installation, Operation and Maintenance
19 Webasto Charging Systems, Inc.