Programming Menus - Webasto DVS100 Installation, Operation And Maintenance Manual

1. Charge Event Log - Allows the user to scroll through the data from the last 250 charge events
(Figure 5-8).
2. Fault/Warning Log - Allows the user to scroll through the last 50 fault or warning events
(Figure 5-7).
3. Charger configuration - A programming mode for setting the date and time, the equalization
status button, controlling charge times and setting special configurations. An access code is
required to enter this mode (Figure 5-11).
4. BMID Data Review - Lists all of the BMID parameters along with all of the stored charge history
and equalization data for the battery currently connected to the charger.
5. BMID Configuration - A programming mode for modifying the BMID parameters of the battery
currently connected. An access code is required to enter this mode (# 06701).
6. Display Application Version Information – Allows user to view software version and hardware
configuration information.
5.10

Programming Menus

Because errors in programming may lead to incorrect charging and reduced battery performance,
the programming must be done by an Authorized Service Technician. The programming menus
are protected from unauthorized use with an access code.
NOTE: Programming should only be performed by experienced fleet managers.
Contact your Authorized DVS dealer for the code, or call Webasto customer service at
The programming menus can change the characteristics of a charge. Therefore, programming is
not possible during active charging. If a programming menu is entered while a vehicle is charging,
the charger will prompt for termination of the charge before allowing programming to continue. The
process for entering either programming mode is shown in Figure 5- 11.
20182-W-03-01
IMPORTANT INFORMATION – SAVE THESE INSTRUCTIONS
info@posicharge.com
866-POSICHARGE (866-767-4242
Figure 5- 11 Programming Menu Entry
DVS100 Installation, Operation and Maintenance
)
25 Webasto Charging Systems, Inc.