Installation; Preparation - Webasto DVS100 Installation, Operation And Maintenance Manual

4 Installation

This section outlines the requirements and procedures for installing the DVS100. Read the entire
section before proceeding with installation, and make sure you have read and understood the
warnings in Section 2. Installation should be completed by an experienced electrician and should
conform to all relevant electrical codes.
4.1

Preparation

Unpacking and Inspection
The DVS100 is provided fully assembled on a shipping pallet. It is surrounded by a protective
shipping box. Remove the packaging and any other shipping materials prior to installation.
The following equipment is provided with each system:
 One DVS100 system
 DVS Installation Manual

CD manual
The following equipment is shipped to truck retrofit location

Two BMID system with related connectors

Two BMID thermistor kit
The "BMID Programming" Manual

NOTE: Additional connector sets and BMID kits may be purchased from your authorized DVS100
Dealer.
20182-W-03-01
IMPORTANT INFORMATION – SAVE THESE INSTRUCTIONS
DVS100 Installation, Operation and Maintenance
6 Webasto Charging Systems, Inc.