6.1.4 REPLACING THE BELTS/SLATS/COMPLETE TREAD
BELT
6.1.4.1 PROCEDURE TO FOLLOW IN CASE OF WEAR OF THE BELTS
AND THE SLATS: REPLACEMENT OF THE COMPLETE TREAD
BELT
Replace the complete tread belt in the following case:
▪ Wear of the belts and the slats.
Necessary components:
ISOFLEX Topas L32 (45g)
The following additional components are required to install the tread belt:
Support for the equipment in a
To facilitate the lifting of the tread belt can also be ordered the following components:
Number of technicians required:
2: If equipped with the accessory that blocks the equipment, when it is in a vertical
position.
3: If not equipped with the accessory that blocks the equipment, when it is in a verti-
cal position. The additional technician must keep the equipment stable when it is in
a vertical position.
Required space: 3-4 m
- 54 -
COMPONENT
Tread belt
COMPONENT
Machine lifting foot
M16 nut
lateral position
M10 L75 screw
COMPONENT
Handle
Safety bushings
2
TECHNOGYM RUN Technical Service Guide
Q.TY
1
1
Q.TY
2
4
1
1
Q.TY
2
8
TSG-00284-EN- Uncontrolled copy if printed
Rev. 1.0