10. Remove the rear pulley.
For details, refer to the disassembly procedure described in the chapter:
$7.21 DISASSEMBLING THE REAR PULLEY
11.
Remove the front and rear footrest guard, on the right and left side of the equipment.
12. Remove the front and rear roller and the untistatic brush.
For details, refer to the disassembly procedure described in the chapter:
$7.22 DISASSEMBLING THE FRONT AND REAR ROLLER
ATTENTION: During reassembly the flange bearing screws on the rollers, apply Loctite
243 on the screw thread.
Tighten the screws with a torque of 22 Nm (16.2 lbf-ft). Apply this procedure to all four
screws.
- 56 -
TECHNOGYM RUN Technical Service Guide
TSG-00284-EN- Uncontrolled copy if printed
Rev. 1.0