Technogym DGK02U0 Technical Service Manual page 92

Check the resistance between the 3 phases of the belt motor:
PIN 1 - PIN 2 ~ 0.9 Ω (including the impedance of the tester)
PIN 1 - PIN 3 ~ 0.9 Ω (including the impedance of the tester)
PIN 2 - PIN 3 ~ 0.9 Ω (including the impedance of the tester)
[6]: Check the Vac of the 3 phases on the drive, with the tread belt moving.
The 3 values measured between:
▪ PIN 1 and the earth
▪ PIN 2 and the earth
▪ PIN 3 and the earth
must be the same (~ 220 Vac)
- 92 -
PIN 1
TECHNOGYM RUN Technical Service Guide
Fig. 51
TSG-00284-EN- Uncontrolled copy if printed
Rev. 1.0
EARTH