Replace The Run Surface; Assembling The Rear Pulley And Tension The Motor Belt; Replace The Breaking Resistor; Replace The Joystich Led Strip - Technogym DGK02U0 Technical Service Manual

7.23 REPLACE THE RUN SURFACE

Perform the procedures illustrated in the videos in the attached folder, according to the following
sequence:
13 - Disassembling the bottom casing
17 - Disassembling the running motor (ONLY belt tension release)
18 - Remove slats
19 - Disassembling the rear pulley
20 - Disassembling the front and rear roller
21 - How to tension the running surface
7.24 ASSEMBLING THE REAR PULLEY AND TENSION
THE MOTOR BELT
Perform the procedures illustrated in the videos in the attached folder, according to the following
sequence:

22 - Assembling the rear pulley and tension the motor belt

7.25 REPLACE THE BREAKING RESISTOR

Perform the procedures illustrated in the videos in the attached folder, according to the following
sequence:
• After removing the bottom casing and the running motor as described in the videos:
13 - Disassembling the bottom casing
17 - Disassembling the running motor (ONLY belt tension release)
• Proceed with:
23 - Replace the breaking resistor

7.26 REPLACE THE JOYSTICH LED STRIP

Perform the procedures illustrated in the videos in the attached folder, according to the following
sequence:
25 - Replace the joystich LED strip
- 102 -
TECHNOGYM RUN Technical Service Guide
TSG-00284-EN - Uncontrolled copy if printed
Rev. 1.0