Table of Contents
Advertisement
TECHNOGYM RUN Technical Service Guide
Rev. 1.0
6.2.3 INSTALLATION OF A NEW TREAD BELT-BELT
REPLACEMENT
•
Take as reference the position of the front pin, right and left side. See the table below.
•
After performing the operations: return the front roller to its original condition.
•
The belt must lightly touch the front bearing. More specifically, there must be a maximum
gap of 1 mm to 2 mm between the belt and the front bearing. The belt may lightly touch the
bearing, but must not be overtensioned: as soon as the belt is in contact with the bearing,
do not rotate the front pin bolt any further. Tuen both the right and left bolts on the front
roller to maintain the parallelism.
Maintain the parallelism of the rollers. This is important as regards the position of the tread
belt on the equipment. Turn one half turn at a time, both on the right and on the left side of
TSG-00284-EN- Uncontrolled copy if printed
Take as reference the distance between the
front roller and the frame, both on the right
and on the left side of the equipment. (TOOL:
gauge).
Alternatively, take as reference the position of
the front shaft, in correspondence of which the
frame "rests". (TOOL: marker)
- 67 -
Advertisement
Table of Contents
