Table of Contents
Advertisement
TECHNOGYM RUN Technical Service Guide
Rev. 1.0
DISPLAY: 'PRESS "YES" TO QUIT THIS MESSAGE AND START TRAINING'");
▪ Communication error ($"6.7 MESSAGE ON THE DISPLAY: 'COMMUNICATION ERROR
- PRESS "YES" TO QUIT THIS MESSAGE'");
cause the following message to appear on the display 'THE EQUIPMENT IS BLOCKED. CON-
TACT TECHNOGYM TECHNICAL SUPPORT'.
6.7 MESSAGE ON THE DISPLAY: 'COMMUNICATION
ERROR - PRESS "YES" TO QUIT THIS MESSAGE'
Click the button on the display to try to make the error disappear. If the error message remains, the
cause is related to a connection problem between the High Kit and the Low Kit:
▪ Check continuity between PIN 1 (drive side) and PIN 13 (display side) and between PIN 5
(drive side) and PIN 5 (display side) - (cable 0WCU1266xx: High Kit - Low Kit connection
cable). If there is no continuity, try to replace the cable 0WCU1266xx. If there is continuity or
if the error continues even after replacing the cable, proceed as indicated below:
▪ Try to replace the drive.
▪ Try to replace the display.
▪ Make sure the problem is solved. For details, see: $"6.15 EQUIPMENT TESTING AFTER
THE INTERVENTION OF TECHNICAL SERVICE".
6.8 MESSAGE ON THE DISPLAY 'PLEASE WAIT':
POSSIBLE CAUSES
The message 'Please Wait' shown on the display can be caused by:
▪ When turning on the equipment, the 6 Vdc (from the display to the Low Kit), are not present at
the Low Kit input (possible causes: microswitch of the stop button, display or Low Kit cable).
For details, see: $"6.8.1 MESSAGE ON THE DISPLAY 'PLEASE WAIT' OR PRESS START
– THE EXERCISE SCREEN APPEARS AND THEN THE SYSTEM AUTOMATICALLY RE-
TURNS TO THE STAND-BY SCREEN".
▪ Short circuit open between PIN 3 and PIN 9 of the Low Kit. The equipment is not able to per-
form the reset;
▪ Incorrect type of equipment selected on the display: for this reason, the communication be-
tween the display and the Low Kit is not established correctly.
TSG-00284-EN- Uncontrolled copy if printed
- 77 -
Advertisement
Table of Contents
