Technogym DGK02U0 Technical Service Manual page 7

TECHNOGYM RUN Technical Service Guide
Rev. 1.0
IN A GOOD CONDITION.......................................................................................59
6.1.4.3 PROCEDURE TO FOLLOW IF A FEW SLATS ARE WORN BUT THE BELTS
ARE IN A GOOD CONDITION ..............................................................................64
6.2 BELT TENSIONING ...................................................................................................65
6.2.1 LOOSENING THE BELT BUT WITHOUT REPLACING IT .................................65
6.2.2 TREAD BELT RELAXED (EFFECTS: NOISY TREAD BELT) ............................66
6.2.3 INSTALLATION OF A NEW TREAD BELT-BELT REPLACEMENT ...................67
6.3 PARAMETERS (STIWI DRIVE) ................................................................................69
6.4 DRIVE ERROR CODE LIST .....................................................................................69
6.5 PROCEDURE FOR RESTORING THE LOW KIT FACTORY SETTINGS .............76
6.6 MESSAGE ON THE DISPLAY: 'THE EQUIPMENT IS BLOCKED. CONTACT
TECHNOGYM TECHNICAL SUPPORT' ..................................................................76
6.7 MESSAGE ON THE DISPLAY: 'COMMUNICATION ERROR - PRESS "YES" TO
QUIT THIS MESSAGE' ..............................................................................................77
6.8 MESSAGE ON THE DISPLAY 'PLEASE WAIT': POSSIBLE CAUSES .................77
6.8.1 MESSAGE ON THE DISPLAY 'PLEASE WAIT' OR PRESS START - THE EX-
ERCISE SCREEN APPEARS AND THEN THE SYSTEM AUTOMATICALLY RE-
TURNS TO THE STAND-BY SCREEN ................................................................78
6.9 ANIMATION ON THE DISPLAY OF DISCONNECTED EMERGENCY, WITH THE
INDICATION TO RE-CONNECT THE EMERGENCY .............................................81
6.10 MESSAGE ON THE DISPLAY: 'DC MOTOR FAULT- PRESS "YES" TO QUIT THIS
MESSAGE'-ERROR 07 DC GRADIENT MOTOR ENCODER ................................85
6.11 TREAD BELT DOES NOT MOVE SMOOTHLY BUT JERKS/ERROR 08 AC BELT
MOTOR ENCODER ...................................................................................................89
6.12 MESSAGE ON THE DISPLAY: 'WARNING: ENCODER MOTOR-PRESS "YES"TO
QUIT THIS MESSAGE'- ERROR 15 LOSS OF IMPULSE ......................................93
6.13 ERROR 13 - MALFUNCTION IN THE 24 VDC POWER DISTRIBUTION .............93
6.14 GYMKIT NOT FUNCTIONING ..................................................................................93
6.15 EQUIPMENT TESTING AFTER THE INTERVENTION OF TECHNICAL SERVICE
94
6.16 WHAT TO DO IN CASE OF EQUIPMENT OUT OF ORDER / BLOCKED .............94
6.17 MESSAGE ON THE DISPLAY: 'PRESS "YES" TO QUIT THIS MESSAGE AND
START TRAINING' .....................................................................................................94
7. PROCEDURES FOR DISASSEMBLY-REASSEMBLY AND REPLACEMENT
OF COMPONENTS ...........................................................................................95
7.1 GENERAL INFORMATION AND WARNINGS .........................................................95
7.1.1 NECESSARY TOOLS............................................................................................95
7.1.2 PERSONAL PROTECTIVE EQUIPMENT ...........................................................96
7.2 EQUIPMENT REFERENCE ......................................................................................96
7.3 DISASSEMBLING THE SPEAKER CASING ...........................................................97
7.4 DISASSEMBLING THE DISPLAY .............................................................................97
TSG-00284-EN - Uncontrolled copy if printed - 7 -