Technogym DGK02U0 Technical Service Manual page 62

14. Remove the gradient motor.
15. Remove the elevation system.
16. Put the equipment in vertical position.
For details, refer to the disassembly procedure described in the chapter:
$7.23 DISASSEMBLING THE RUN SURFACE
Details about the disassembling of the elevation system:
Remove the two screws indicated, (TOOL: 6 mm hexagon key wrench).
ATTENTION: During reassembly the pin of the elevation system, Apply Loctite 243 on the
thread of the pin.
- 62 -
TECHNOGYM RUN Technical Service Guide
TSG-00284-EN- Uncontrolled copy if printed
Rev. 1.0