Procedure To Follow If A Few Slats Are Worn But The Belts Are In A Good Condition - Technogym DGK02U0 Technical Service Manual

6.1.4.3 PROCEDURE TO FOLLOW IF A FEW SLATS ARE WORN BUT
THE BELTS ARE IN A GOOD CONDITION
Necessary components:
Plates (to be positioned between the slats
and the self-locking nuts)
Number of technicians required: 1
PROCEDURE:
1. Turn off the equipment. Disconnect the power supply cable.
2. Remove the front and side casing, on the right and left side of the equipment.
For details, refer to the disassembly procedure (see the attached video):
13 - Disassembling the bottom casing
3. Remove the front and rear footrest guard, on the right and left side of the equipment.
For details, refer to the disassembly procedure described in the chapter:
$7.22 DISASSEMBLING THE FRONT AND REAR ROLLER
4. Remove the worn slats from the belts. If necessary, remove the rubber strips between the
belt and slats.
For details, refer to the disassembly procedure (see the attached video):
18 - Remove slats
5. If necessary, insert the rubber strips between the belts and slats. Fit the new slats with the
new self-locking nuts and the new plates.
- 64 -
COMPONENT
Self-locking nuts
Rubber strips
Slats
TECHNOGYM RUN Technical Service Guide
Q.TY
2 for each replaced slat
4 for each replaced slat
1 rubber strip for every 10 slats
the quantities depends on the
number of slats to replace
TSG-00284-EN- Uncontrolled copy if printed
Rev. 1.0