Standby Settings; Standby Bootaction; Standby Control; Standby Delay - Cisco Webex Room Panorama Administrator's Manual

Cisco Webex Room Panorama and Room 70 Panorama

Introduction

Standby settings

Standby BootAction

Define the camera position after a restart of the video conferencing device.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: DefaultCameraPosition
Value space: None/DefaultCameraPosition/RestoreCameraPosition
None: No action.
RestoreCameraPosition: When the video conferencing device restarts, the camera
returns to the position that it had before the restart.
DefaultCameraPosition: When the video conferencing device restarts, the camera
moves to the factory default position.

Standby Control

Define whether the device should go into standby mode or not.
Requires user role: ADMIN, INTEGRATOR
Default value: On
Value space: Off/On
Off: The device will not enter standby mode.
On: The device will enter standby mode when the Standby Delay has timed out.

Standby Delay

Define how long (in minutes) the device shall be in idle mode before it goes into standby
mode. Requires the Standby Control to be enabled.
Requires user role: ADMIN, INTEGRATOR
Default value: 10
Value space: Integer (1..480)
Set the standby delay (minutes).
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals Maintenance

Standby Signage Audio

By default, a device does not play out audio in digital signage mode even if the web page
has audio. You can use this setting to override the default behavior.
Requires user role: ADMIN, INTEGRATOR
Default value: Off
Value space: Off/On
Off: The device does not play out audio with the web page.
On: If the web page has audio, the device plays it out. The volume follows the volume
setting of the device.

Standby Signage Mode

Content from a URL (a web page) can replace the traditional half-wake background image
and information. This feature is called digital signage.
The use of digital signage does not prevent the device from entering standby the normal
way. Therefore, the Standby Delay setting determines for how long the digital signage is
shown before the device goes into standby.
Requires user role: ADMIN, INTEGRATOR
Default value: Off
Value space: Off/On
Off: Digital signage is not enabled on the device.
On: Digital signage is enabled and replaces the device's half-wake mode, provided that
also the WebEngine Mode setting is On.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
155
Administrator Guide
Device settings Device settings Appendices