Httpfeedback Settings; Httpfeedback Tlsverify; Httpfeedback Usehttpproxy - Cisco Webex Room Panorama Administrator's Manual

Cisco Webex Room Panorama and Room 70 Panorama

Introduction

HttpFeedback settings

HttpFeedback TlsVerify

This setting applies when a video conferencing device connects to an HTTPS server
for arbitrary HTTPS communication (refer to the HttpClient Post/Put/Patch/Get/Delete
commands). For phone book, provisioning, and external logging servers, see the
Phonebook Server 1 TlsVerify, Provisioning TlsVerify, and Logging External TlsVerify
settings.
Before establishing a connection between the device and the HTTPS server, the device
checks if the certificate of the server is signed by a trusted Certificate Authority (CA). The
CA certificate must be included in the CA list on the device, either pre-installed or manually
uploaded using the web interface or API.
In general, the minimum TLS (Transport Layer Security) version for the HTTPS connection
is 1.1. There are two exceptions to this rule: 1) For compatibility reasons, the minimum TLS
version is 1.0 for devices that are registered to CUCM. 2) Devices registered to the Webex
cloud service always use version 1.2.
Note: The value is set to Off for a device that has been upgraded to CE9.9 (or later) from
CE9.8 or earlier software versions, provided that the device has not been factory reset after
the upgrade, and that the old NetworkServices HTTPS VerifyServerCertificate setting was
not explicitly set to On.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The device doesn't check the certificate of the HTTPS server.
On: The device checks if the certificate of the HTTPS server can be trusted. If not, the
connection between the device and the server is not established.
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals Maintenance

HttpFeedback UseHttpProxy

There are several UseHttpProxy settings that specify if a service shall communicate via an
HTTP proxy or not. The HttpFeedback UseHttpProxy setting applies to feedback sent from
the video device.
For this setting to have any effect, a proxy server for HTTP, HTTPS, and WebSocket traffic
must be set up using the NetworkServices HTTP Proxy settings.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: Set up communication directly with the server (not using a proxy).
On: Set up communication via proxy.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
114
Administrator Guide
Device settings Device settings Appendices