Standby Settings; Standby Standbyaction; Standby Wakeupaction; Standby Wakeuponmotiondetection - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set

Introduction

Standby settings

Standby BootAction

Define the camera position after a restart of the codec.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: RestoreCameraPosition
Value space: None/DefaultCameraPosition/RestoreCameraPosition
None: No action.
RestoreCameraPosition: When the video system restarts, the camera returns to the
position that it had before the restart.
DefaultCameraPosition: When the video system restarts, the camera moves to the
factory default position.

Standby Control

Define whether the system should go into standby mode or not.
Requires user role: ADMIN, INTEGRATOR
Default value: On
Value space: Off/On
Off: The system will not enter standby mode.
On: The system will enter standby mode when the Standby Delay has timed out.
Requires the Standby Delay to be set to an appropriate value.

Standby Delay

Define how long (in minutes) the system shall be in idle mode before it goes into standby
mode. Requires the Standby Control to be enabled.
Requires user role: ADMIN, INTEGRATOR
Default value: 10
Value space: Integer (1..480)
Set the standby delay (minutes).
D15330.14 SX10 Administrator Guide CE9.7, APRIL 2019.
Configuration Peripherals Maintenance

Standby StandbyAction

Define the camera position when going into standby mode.
Requires user role: ADMIN, INTEGRATOR
Default value: PrivacyPosition
Value space: None/PrivacyPosition
None: No action.
PrivacyPosition: When the video system enters standby, the camera turns to a sideways
position for privacy.

Standby WakeupAction

Define the camera position when leaving standby mode.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: RestoreCameraPosition
Value space: None/RestoreCameraPosition/DefaultCameraPosition
None: No action.
RestoreCameraPosition: When the video system leaves standby, the camera returns to
the position that it had before entering standby.
DefaultCameraPosition: When the video system leaves standby, the camera moves to
the factory default position.

Standby WakeupOnMotionDetection

Automatic wake up on motion detection is a feature that will sense when a person walks into
the room. The feature is based on ultrasound detection.
Requires user role: ADMIN, INTEGRATOR
Default value: Off
Value space: Off/On
Off: The wake up on motion detection is disabled.
On: Not applicable in this version.
www.cisco.com — Copyright © 2019 Cisco Systems, Inc. All rights reserved.
142
Administrator Guide
System settings System settings Appendices