Standby Settings; Standby Control; Standby Delay; Standby Wakeuponmotiondetection - Cisco DX70 Administrator's Manual

Cisco DX70 and DX80

Introduction

Standby settings

Standby Control

Define whether the system should go into standby mode or not.
Requires user role: ADMIN, INTEGRATOR
Default value: On
Value space: Off/On
Off: The system will not enter standby mode.
On: The system will enter standby mode when the Standby Delay has timed out.
Requires the Standby Delay to be set to an appropriate value.

Standby Delay

Define how long (in minutes) the system shall be in idle mode before it goes into standby
mode. Requires the Standby Control to be enabled.
Requires user role: ADMIN, INTEGRATOR
Default value: 10
Value space: Integer (1..480)
Set the standby delay (minutes).

Standby WakeupOnMotionDetection

Automatic wake up on motion detection is a feature that will sense when a person walks
into the room. The feature is based on ultrasound detection, and the Proximity Mode setting
must be On to make the feature work.
Requires user role: ADMIN, INTEGRATOR
Default value: Off
Value space: Off/On
Off: The wake up on motion detection is disabled.
On: When people walk into the room the system will automatically wake up from standby
(only applicable to DX80).
D15362.06 DX70 and DX80 Administrator Guide CE9.2, NOVEMBER 2017.
Configuration Peripherals Maintenance
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
113
Administrator Guide
System settings System settings Appendices