Httpfeedback Address From Tms - Cisco Webex Room Panorama Administrator's Manual

Cisco Webex Room Panorama and Room 70 Panorama Administrator Guide

Introduction Configuration Peripherals Maintenance Device settings Appendices Appendices

HTTPFeedback address from TMS

When a device is added to Cisco TelePresence Management
Suite (TMS), it is automatically configured to send information
(events) back to TMS. The device receives the address, that these
events should be sent to, from TMS (HTTPFeedback address). If
this address is absent or misconfigured, the device cannot send
events to TMS.
Missing response to events
If the device does not receive a response to an event, it will
retry sending it to the HTTPFeedback address up to 6 times at
increasing intervals.
If the device does not receive a response to any of the retries, the
endpoint tries to send a message to the HTTPFeedback address
every ten minutes. The HTTPFeedback status will indicate that it
has failed, and there is a diagnostic message indicating the type
of failure.
While retrying to send messages, there will be a loss of Call Detail
Records (CDR) on TMS.
Get a new HTTPFeedback address from TMS
In order to get a new address to send events to, you must restart
the device and wait for the next management address push from
TMS (scheduled or triggered by the TMS administrator).
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020. www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
226