Standby Settings; Standby Bootaction; Standby Control; Standby Delay - Cisco TelePresence SX20 Quick Set Administrator's Manual

Cisco TelePresence SX20 Quick Set

Introduction

Standby settings

Standby Control

Define whether the system should go into standby mode or not.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The system will not enter standby mode.
On: The system will enter standby mode when the Standby Delay has timed out.
Requires the Standby Delay to be set to an appropriate value.

Standby Delay

Define how long (in minutes) the system shall be in idle mode before it goes into standby
mode. Requires the Standby Control to be enabled.
Requires user role: ADMIN
Default value: 10
Value space: Integer (1..480)
Set the standby delay (minutes).

Standby BootAction

Define the camera position after a restart of the codec.
Requires user role: ADMIN
Default value: RestoreCameraPosition
Value space: None/DefaultCameraPosition/RestoreCameraPosition
None: No action.
RestoreCameraPosition: When the video system restarts, the camera returns to the
position that it had before the restart.
DefaultCameraPosition: When the video system restarts, the camera moves to the
factory default position.
D15329.03 SX20 Administrator Guide CE8.2, JUNE 2016.
Configuration Peripherals Maintenance

Standby StandbyAction

Define the camera position when going into standby mode.
Requires user role: ADMIN
Default value: PrivacyPosition
Value space: None/PrivacyPosition
None: No action.
PrivacyPosition: When the video system enters standby, the camera turns to a sideways
position for privacy.

Standby WakeupAction

Define the camera position when leaving standby mode.
Requires user role: ADMIN
Default value: RestoreCameraPosition
Value space: None/RestoreCameraPosition/DefaultCameraPosition
None: No action.
RestoreCameraPosition: When the video system leaves standby, the camera returns to
the position that it had before entering standby.
DefaultCameraPosition: When the video system leaves standby, the camera moves to
the factory default position.
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
121
Administrator Guide
System settings System settings Appendices