Cisco Webex Room Panorama Administrator's Manual page 59

Cisco Webex Room Panorama and Room 70 Panorama

Introduction
Connect the Touch 10 controller
Room 70 Panorama
Touch 10 must either be directly connected to the video
conferencing device as described on this page, or paired
to the device via the network (LAN) as described on the
next page. The latter is referred to as remote pairing.
Connect Touch 10 directly to the video
conferencing device
Note: This chapter doesn't apply to Room Panorama; only
to Room 70 Panorama.
Connect Touch 10 to the video conferencing device's
dedicated Touch (RJ-45) port as illustrated.
Touch 10 set-up
Once Touch 10 is connected to power, the set-up
procedure begins. Follow the instructions on screen.
If Touch 10 needs software upgrade, new software will
be downloaded from the video conferencing device and
installed on the unit automatically as part of the set-up
procedure. Touch 10 restarts after the upgrade.
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals Peripherals
(page 2 of 5)
Remove the side cover to get
access to the connector panel.
Maintenance
Codec connector panel
Contact information
The video conferencing device's
name or address is displayed in
the status bar when Touch 10 is
successfully connected to the
device.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
59
Administrator Guide
Device settings Appendices
PoE rated Ethernet cable
The Ethernet connector
is at the rear of Touch 10.