Gpio Settings; Gpio Pin [N] Mode - Cisco Webex Room Panorama Administrator's Manual

Cisco Webex Room Panorama and Room 70 Panorama

Introduction

GPIO settings

GPIO Pin [n] Mode

n: 1..4
The four GPIO pins are configured individually. The actual measured pin state (Low/High)
can be retrieved by the GPIO Pin [1..4] State status.
The default state for a pin in output mode is High (+12 V).
NOTE: A pin defined to output mode can be set to force line Low actively. If set to High, the
line will be high only when it is not connected to an external device that pulls the line low.
Requires user role: ADMIN, INTEGRATOR
Default value: InputNoAction
Value space: InputAcceptAllCalls/InputDisconnectAllCalls/InputMuteMicrophones/
InputNoAction/OutputAllCallsEncrypted/OutputInCall/OutputManualState/
OutputMicrophonesMuted/OutputPresentationOn/OutputStandbyActive
InputAcceptAllCalls: When the pin transitions from High to Low on an incoming call, the
call will be accepted (the Call Accept command is issued automatically).
InputDisconnectAllCalls: When the pin transitions from High to Low during a call, call(s)
will be disconnected (the Call Disconnect command is issued automatically).
InputMuteMicrophones: When the pin transitions from High to Low during a call, the
microphones will be muted. When the pin transitions from Low to High during a call, the
microphones will be unmuted (the Audio Mute and Audio Unmute commands are issued
automatically).
InputNoAction: The pin state does not trigger any action. The pin state can be read with
the GPIO Pin [1..4] State status.
OutputAllCallsEncrypted: The pin is set Low when all calls are encrypted, and High when
one or more calls are not encrypted.
OutputInCall: The pin is set Low when in call, and High when not in call.
OutputManualState: The pin state can be set to High or Low by the GPIO ManualState
Set PinX command. It is set to +12 V or 0 V, respectively.
OutputMicrophonesMuted: The pin is set Low when the microphones are muted, and
High when they are not muted.
OutputPresentationOn: The pin is set Low when a presentation is active, and High when
a presentation is not active.
OutputStandbyActive: The pin is set Low when the device is in standby mode, and High
when the device is not in standby mode.
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals Maintenance
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
109
Administrator Guide
Device settings Device settings Appendices