How To Administer The Video Conferencing Device - Cisco Webex Room Panorama Administrator's Manual

Cisco Webex Room Panorama and Room 70 Panorama

Introduction Introduction

How to administer the video conferencing device

In general, we recommend you to use the web interface
to administer and maintain the device, as described in
this administrator guide.
Alternatively, you can access the API of the device by
other methods:
• HTTP/HTTPS (also used by the web interface)
• WebSocket
• SSH
• Serial connection
If you want more information about the different access
methods, and how to use the API, refer to the API guide
for the device.
Tip
If the configuration or status is available in the API, the
web interface setting or status translates into an API
configuration or status as follows:
Set X > Y > Z to Value (web)
is the same as
xConfiguration X Y Z: Value
(API)
Check X > Y > Z status (web)
is the same as
xStatus X Y Z
(API)
For example:
Set SystemUnit > Name to MySystem
is the same as
xConfiguration SystemUnit Name: MySystem
Check SystemUnit > Software > Version
is the same as
xStatus SystemUnit Software Version
More settings and statuses are available in the web
interface than in the API.
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals
Access method
HTTP/HTTPS
WebSocket
SSH
Serial connection
If all access methods are disabled (set to Off), you can no longer configure the device. You are not able to re-enable
(set to On) any of the access methods, and you must factory reset the device to recover.
status
Maintenance
(page 1 of 4)
Notes
• Used by the web interface of the device
• Non-secure (HTTP) or secure (HTTPS) communication
• HTTPS: Enabled by default
• HTTP: Enabled by default only for devices that have been
upgraded to CE9.4 (or later) from an earlier software
version, provided that the device has not been factory
reset after the upgrade
• Tied to HTTP, so that also HTTP or HTTPS must be
enabled before you can use WebSocket
• Encrypted (wss) or unencrypted (ws) communication
• Disabled by default
• Secure TCP/IP connection
• Enabled by default
• Connect to the device with a cable. IP-address, DNS, or
a network is not required
• Enabled by default
• We recommend using the default baud rate, because
the device may return much feedback
BaudRate)
• For security reasons, you are asked to sign in by default
(SerialPort > LoginRequired)
15
Administrator Guide
Device settings
How to enable/disable the methods
NetworkServices > HTTP > Mode
Restart the device for changes to take
effect
NetworkServices > HTTP > Mode
NetworkServices > Websocket
Restart the device for changes to take
effect
NetworkServices > SSH > Mode
You do not need to restart the device.
It may take some time for changes to
take effect
SerialPort > Mode
Restart the device for changes to take
effect
(SerialPort >
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
Appendices