Phonebook Settings; Phonebook Server [N] Id; Phonebook Server [N]; Phonebook Server [N] Tlsverify - Cisco Webex Room Panorama Administrator's Manual

Cisco Webex Room Panorama and Room 70 Panorama

Introduction

Phonebook settings

Phonebook Server [n] ID

n: 1..1
Define a name for the external phone book.
Requires user role: ADMIN
Default value: ""
Value space: String (0, 64)
The name for the external phone book.
Phonebook Server [n] Pagination
n: 1..1
Configure if the phonebook server supports pagination (paging) or not. Pagination means
that the server supports consecutive searches, and these searches can be relative to an
offset. This allows the user interface to perform as many consecutive searches as required
to get the complete search result.
If Pagination is Disabled the device does a single search and returns a maximum of 100
entries in the search result. It is not possible to scroll to any further search results beyond
that.
Requires user role: ADMIN
Default value: Enabled
Value space: Disabled/Enabled
Disabled: The phonebook server does not support pagination. The device does a single
search, and the maximum number of entries in the search result is 100.
Enabled: The phonebook server supports pagination.
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals Maintenance

Phonebook Server [n] TlsVerify

This setting applies when a video conferencing device connects to an external phone book
server via HTTPS.
Before establishing a connection between the device and the HTTPS server, the device
checks if the certificate of the server is signed by a trusted Certificate Authority (CA). The
CA certificate must be included in the CA list on the device, either pre-installed or manually
uploaded using the web interface or API.
In general, the minimum TLS (Transport Layer Security) version for the HTTPS connection
is 1.1. There are two exceptions to this rule: 1) For compatibility reasons, the minimum TLS
version is 1.0 for devices that are registered to CUCM. 2) Devices registered to the Webex
cloud service always use version 1.2.
Note: The value is set to Off for a device that has been upgraded to CE9.9 (or later) from
CE9.8 or earlier software versions, provided that the device has not been factory reset after
the upgrade, and that the old NetworkServices HTTPS VerifyServerCertificate setting was
not explicitly set to On.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The device doesn't check the certificate of the HTTPS server.
On: The device checks if the certificate of the HTTPS server can be trusted. If not, the
connection between the device and the server is not established.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
135
Administrator Guide
Device settings Device settings Appendices