Test The Loudspeaker Connections - Cisco Webex Room Panorama Administrator's Manual

Cisco Webex Room Panorama and Room 70 Panorama

Introduction

Test the loudspeaker connections

Room 70 Panorama
Sign in to the web interface and navigate to
Developer API.
We have provided a speaker check tool that you can run to
verify that the loudspeakers are correctly connected.
You must be in the same room as the video conferencing
device when you test the loudspeaker connections.
Run the loudspeaker check
1. Enter the following command in the Execute API
commands and configurations text area:
xCommand Audio SpeakerCheck
MeasurementLength: <number of seconds>
Volume: <test-signal volume>
MeasurementLength
If you leave out the
parameters, the test signal is emitted for 1 second from
each speaker, and the volume is 1.
2. Click Execute.
The speaker check will now run, and a test signal will be
emitted from each speaker, in sequence from left to right.
3. Listen for the test signals.
If one or more speakers do not make a sound, or the
sequence is not strictly from left to right, you have to
reconnect the loudspeaker cables and run the speaker
check again.
Syntax and semantics are explained in the API guide for the device.
*
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals Peripherals
(page 1 of 2)
Find the correct cable for each loudspeaker
Integration >
1
The numbers that are shown
in the illustration are printed
on the loudspeaker cables.
*
Volume
and
Maintenance
2
3
4
1
2
3
4
55
Administrator Guide
Device settings
Loudspeakers
It is crucial for the conferencing
experience that the device's
loudspeakers are correctly connected to
the embedded codec.
Correct cabling ensures that sound meant
to be coming from the right loudspeakers
actually comes from the right speakers,
and the sound meant to be coming from
the left loudspeakers actually comes from
the left speakers. If the speaker cables
are incorrectly connected this will not
take place.
If the speaker check reveals any issues,
you must reconnect the cables.
How to reconnect cables
Check the Installation Guide for the
product for all details.
1. Remove the device's upper textile
grille. It snaps to magnets.
2. Then, release the speaker gently from
its peg.
3. Disconnect the cable that is
connected incorrectly, and connect
the correct cable.
The cables are marked with a
number, as shown in the illustration to
the left.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
Appendices